Channel radio control system instruction manual • Read online or download PDF • Futaba 3PK User Manual. View and Download FUTABA 3PK instruction manual online. 3-CHANNEL RADIO CONTROL SYSTEM. 3PK Remote Control pdf manual download. View and Download FUTABA 3PKS instruction manual online. download. Also for: Magnum 3pk super. Remote Control FUTABA 3PK Instruction Manual.

Author: Gudal Dazuru
Country: Trinidad & Tobago
Language: English (Spanish)
Genre: Marketing
Published (Last): 19 April 2016
Pages: 194
PDF File Size: 17.12 Mb
ePub File Size: 20.40 Mb
ISBN: 922-3-70078-639-6
Downloads: 26432
Price: Free* [*Free Regsitration Required]
Uploader: Dainris

S Sets the rate at which the ser- DTY duty: The programmable mixing 1 and pro- grammable mixing 2 set-up screens are independent. Two programmable mixing systems can be used. Usually takes advantage of peak charging capability. We immediately began to evaluate the backlog of Futaba parts and service requests, completing what could be done with available parts.

FUTABA 3PKS Instruction Manual

User name display When the END button is held down for 1 second or longer at the initial screen, the Futaba logo and user name are displayed for about 2 seconds.

When the END button is held down for 1 second or longer at the initial screen, the Futaba logo and user name are displayed for about 2 seconds.

Electronic speed control used to vary electric motor RPM. Changing wheel position 1.


Level lv3 only servo view servo | Futaba 3PK User Manual | Page 39 / 68 | Original mode

Model numbering for model memories stored in the optional extended memory CAM Pac. Turn it back on. If the alarm is not generated, there is no problem. Page 52 Changing wheel position 1. Modifying for left-hand use 1. Setup items Point in current setup 1: See Direct Servo Control.

Futaba 3-channel, fhss radio control system for car 23 pages. Provide receiver pre-recorded instructions of how to perform in the event it does not receive clean, clear transmission from a transmitter on its channel in Futaba PCM language. Over current protection Charging The transmitter charging circuit is equipped with an over cur Engine Cut function adjustment Setup item selection Preparation – Select by JOG button up or – Use the function select switch page 79 to select the switch.

The menu type can be set for each model.

May adjust either toward higher idle U or toward braking D. If you have purchased this product from an exporter outside your country, and not the authorized Futaba distributor in your country, please contact the seller immediately to determine if such export regulations have been met. Set ups to fit specific needs of boat models rather than cars. For a description of how to install the battery holder to the transmitter, see “Ni-cad Re- placement” on page P” and make the following adjustments.


Page 51 – Changing Wheel Position and Modifying fo Adjuster Adjuster Similarly, all transmitters need regular maintenance to keep everything properly aligned.


Amount of brake return, how far the braking response is decreased during the pulses. Page 57 Base Load Antenna: Used to replace the longer stock antenna. Tone sounds 7 times and stops re Operation – When braking, mixing is applied to 2nd channel 3rd channel.

The setting is stored within the programming and the onscreen displays continue to show neutral. Ni-cad Battery Replacement Ni-cad Battery Replacement The Ni-cad battery is connected by a connector so that it can be removed when you will not be using the transmitter for a long time, or when replacing a dead battery with a spare battery.

Servo Installation When you install the servos always use the rubber grommets provided in servo hardware bags.

Regular stop watch timer.